Adventures in Hardware Installation
[Blaugust Day 27]
Remember that GTX 970 card I ordered? It arrived Tuesday, but tonight was the first time I had a chance to dedicate to sweating bullets installing it. I’m not sweating because I’m nervous around electronics, I’m sweating because if something goes wrong, I’d be out a lot of money when alternatives were available. Plus, it’d be an embarrassing story, like failing your driver’s test 2-3 times when you’re the high school Valedictorian.
…you know, as a hypothetical example. I’d feel real bad for that
guy person. If they existed.
In any case, I cracked open my PC case and started poking around:
The hardest part of the 560ti removal was the damned power cables. In addition to having some sort of devil-spawn locking mechanism, they felt like they were super-glued on the card. Worrying about static is one thing, but the true nightmare to me is all the wiggling, pushing, and (cringe) bending of hundred-dollar electronics that sometimes becomes necessary.
After much consternation, I managed to unseat the power cords. At which time I unboxed the GTX 970 with the care of holding some distant cousin’s infant that they just threw into your arms like some kind of crazy person. Here is a comparison shot:
Incidentally, that gross-looking stuff in the sink is dust from inside my computer case. While I do periodically clean with a can of compressed air, in my immense wisdom it appears that that cleaning never extended to the video card’s fans. Absolutely filthy, man. I’m surprised the card never burst into flame. Now that I think about it, I’m not entirely sure how safe it was these last four years to have those dumb stickers stuck on the top of the circuitry. I had been assuming it was kosher since it came like that from the shop, but I never really did double-check…
Installing the 970 was pretty easy, by the way. Push it into the slot until it clicks, hand-tighten the case screw and then plug…
Turns out that when you upgrade to a smaller card, and the designers move the power plugs to the side for no discernible reason, you’re going to have a bad time.
So at this point, I start an increasingly desperate bid to cut the zip ties inside my case to free up more power cable slack so I can plug the damn thing in. First, kitchen scissors. Second, a sharp knife in a sawing motion. Third, the Swiss Army Knife I typically use to cut open packages. When that didn’t work, I tried the scissor attachment of the Swiss Army Knife. Success! I ended up having to cut through two zip ties to get enough slack to plug it in.
And here I am, having finished taking the card for a test drive:
I feel better about this investment already.